(800) 282-5359

About

Careers

24 HOUR EMERGENCY DISPATCH

800-282-5359

Get a Quote

Generac HTS Transfer Switches

HTS Transfer Switch

Generac HTS transfer switches are a microprocessor-based design for operation in conjunction with the PowerManager® H-100 or G-100 controller. HTS switches monitor utility voltage and frequency, and communicate via a RS485 communication link to the generator controllers. External LED indicate switch position and source status. An external, 3-position test switch allows testing in either normal or fast mode without opening the cabinet.

Generac HTS

  • The Generac HTS Transfer Switch is a “State of the Art” Smart Switch Designed to Operate in Conjunction With the Generac H100 Series Generator Controller
  • The HTS Transfer Switch Has a Two Wire RS-485 Communication Link to the Generator Controller
  • Utility Voltage is Monitored by the HTS Along With Signal Before Transfer Timing, Time Delay Neutral and Inphase Transfer
  • Switch Operation is Instigated by the Generator Controller
  • All Timers and Voltage Setpoints are Programmable Through GenLink® Communications Software
  • Time Delay Neutral and Inphase Monitor are Included

600-1000 Amp Transfer Switches

Standard Features
  • Electrically Operated and Mechanically Held
  • Programmable Exercise Time
  • Main Contacts are Silver Alloy to Resist Welding and Sticking
  • Conformal Coating Protects All Printed Circuit Boards
  • Indicating LEDs for Switch Position, Standby Operating, Utility Available
  • UL 1008 Listed
  • SPDT Auxiliary Contacts
  • Operator Interface: Test, Fast Test, Return to Utility, Reset
  • Arc Chutes on Main Contacts
  • Signal Before Transfer Contacts
  • Rated to All Classes of Loads
  • Remote Start, Stop and Transfer Through GenLink® Communications Software
  • Up to Four Transfer Switches Per Generator
  • 50/60 Hertz Operation
A Generac brand generator with an ACF Standby Systems automatic transfer switch mounted on a wall.
Backup power equipment mounted on a brick wall, including an ACF Standby Systems Generac generator transfer switch.

1200-2600 Amp Transfer Switches

Standard Features
  • Electrically Operated and Mechanically Held
  • Programmable Exercise Time
  • SPDT Aux Contacts
  • Main Contacts are Silver Alloy
  • Conformal Coating Protects the Printed Circuit Board
  • UL1008 Listed
  • Indicating LED’s for Switch Position, Standby Operating, Utility Available
  • 3 Position Test Switch: Fast Test, Auto, Normal Test
  • Arc Shutes on Main Contacts
  • Signal Before Transfer Contacts
  • Rated to All Classes of Loads
  • Remote Start, Stop and Transfer Through GenLink® Communications Software
  • Up to Four Transfer Switches Per Generator
  • 50/60 Hertz Operation

Quote Request Form